Features:
► Depth, time and oxygen sensor display
► 180deg rotating display
► Buhlmann algorithm with user configurable gradient factor conservatism
► External battery compartment
► Automatic switch-on by depth and/or pressure
► Automatic ambient light sensing LCD illumination
► High/Low PO2 and Deco violation alarm
► Fully independent HUD with three cell real time and simultaneous PO2 indication
► Imperial and metric displays
► Two set points, each of which can be set between .4 and 1.4
► User definable oxygen content of supply gas
► A menu system that adapts to diving status
► Automatic turn off after 30 minutes on the surface
► Set point is controlled and sensors displayed while in menus
► Handset crush depth exceeds 185 meters, head has no limit
► Recommended depth limits; 40m Nitrox, 167m Trimix.
► Any combination of oxygen, nitrogen, and helium
► Open and closed circuit gas list, switchable during a dive
► 5 CC and 5 OC user selectable gases
► Gases can be enabled/disabled, changed and added during a dive
► CNS tracking
► No lockout
► Automatic setpoint switching (configurable)
► Battery life of up to 360 hours
► Backup battery to allow battery change without losing tissues
► Adaptive PID setpoint control
► Total control calibration system
► Automatic diluent flush display calculation
► Millivolt display for all cells “on demand”
► Easy oxygen cell replacement
► Robust, single billet manufactured head
► User serviceable wiring loom
► Critical components protected in the event of a flooding
► “Single moving part” failure tolerant and user serviceable solenoid
► Solenoid failure detection system
► Built in 4th cell holder
► Completely independent power supplies for the Controller, HUD and solenoid
► End user updateable firmware via infra red interface